1. Grounding of the sensor. Discount Insertion Electromagnetic Flowmeter factory tells you that in order to make the split type electromagnetic flowmeter work reliably, improve measurement accuracy, and not be disturbed by external parasitic potentials, the sensor should have a good separate grounding wire, and the grounding resistance should be <10Ω.

2. Requirements for the external environment. 1) The Discount Insertion Electromagnetic Flowmeter factory tells you that the flowmeter should not be installed in a place where the temperature changes greatly or is exposed to high-temperature radiation from the equipment. If it must be installed, measures must be taken for heat insulation and ventilation. Discount Insertion Electromagnetic Flowmeter factory tells you 2). It is best to install the flowmeter indoors. If it must be installed outdoors, it should avoid rainwater, flooding and sun exposure, and moisture-proof and sun-proof measures must be taken.
3), Discount Insertion Electromagnetic Flowmeter factory tells you that the flowmeter should be avoided to be installed in an environment containing corrosive gases, and when it must be installed, ventilation measures must be taken. 4) For the convenience of installation, maintenance, and maintenance, there must be sufficient installation space around the flowmeter. 5) The installation site of the flowmeter should avoid strong magnetic fields and strong vibration sources. If the pipeline vibrates greatly, there should be support for fixing the pipeline on both sides of the flowmeter.
Through the above introduction and analysis of the installation considerations for Discount Insertion Electromagnetic Flowmeter factory, hope it helps you.